Estimate example · Electrical contracting

Commercial Electrical Estimate: Restaurant Build-Out

A 7-page electrical estimate for a restaurant build-out: points counted from drawings, panel load summary, per-point prices, fixture allowance and alternates.

Free plan available. No credit card required. See more document examples

At a glance

This example in numbers

About this example

This example is the estimate an electrical contractor in Denver gives a restaurant owner for the build-out of a 2,400 square foot noodle bar: a new 225 amp panel and feeder, receptacles and dedicated circuits, dining and kitchen lighting with a dimming system, power to the hoods, walk-in cooler and cooking line, and the shunt trip that ties the hood suppression into the panel.

Commercial electrical work is estimated by counting points on the drawings, so this estimate shows that count. A summary gives the total, the 203 points counted and the five-week schedule, then the three assumptions the price depends on. A table ties each category to the drawing sheet it was counted from, a scope page separates the electrician's work from other trades, and a panel load summary shows the new service is sized right. Costs run through five sections at installed prices per point, with a 5% contingency, followed by an allowance for the decorative fixtures the owner is still choosing, three priced alternates, the schedule and the terms.

Who it is for

Electrical contractors who estimate tenant build-outs, restaurants, shops and offices from drawings for owners and general contractors.

Inside and how to use it

What this example contains, and how to make it yours

What's inside

  • A cover and summary with the points counted and the schedule
  • The assumptions behind the price and the drawing sheets used
  • Scope of work with exclusions and a panel load summary
  • Per-point prices in five sections, with a contingency line
  • A fixture allowance and three priced alternates
  • Schedule, terms and an acceptance block

How to adapt it

  • Price devices and fixtures per point from your own labour units
  • Name the drawing sheet behind every count
  • Budget fixtures the owner has not chosen as an allowance
  • Keep alternates like EV charging out of the base price

Ready to make your own?

Build a document like this one, free, in minutes.